Do Electric Brakes Included With Dexter Axles Need To Be Adjusted

Question

Question:

Is there a need to adjust the electric brakes when I install new dexter axles or are they already adjusted? Thanks

asked by: Bradford T

0

Expert Reply:

The brakes that are included with the Dexter axles will need to be adjusted when you install the axles.

To adjust the brakes you can use a small screwdriver or a tool like part # W80630 to turn the adjustment wheel. The wheel pushes out the shoes. You will keep turning the wheel until the pads lightly, but consistently, drag on the drum.

expert reply by: Jeffrey L

0

Answer 1

First thing I'd check is to see if the spindle nut is on too tight. If the brakes are tensioned properly and there's still more drag on one when than the other most likely somebody tightened the spindle nut too much. The spindle nut…

view full answer...

Answer 2

In order to adjust manual trailer braking assemblies you will first need the correct tool which is the Brake Adjustment Spoon part #W80630. Once you have this tool you can remove the rubber plug from the back of the braking assembly, spin the…

view full answer...

Answer 3

To adjust the brakes, you will need to raise the trailer and secure it on adequate capacity jack stands. Check that the wheel and drum rotate freely. Do not lift or support trailer on any part of the axle or the suspension system. Remove the…

view full answer...

Answer 4

Yes, the magnet retaining clips #AKBRKR-MC will fit the brake assembly for an 8,000 pound Dexter axle.

view full answer...

Answer 5

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 6

The age of the tire that comes with the Westlake ST205/75R15 Radial Trailer Tire w/ 15" Silver Mod Wheel part #LHAW121 will vary but as we sell a lot of tires they get rotated in and out very quickly which means most only sit on the shelf a…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 12

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...