Recommended Weld-On Swivel Jack to Fit a 20 Ft. Triton Boat Trailer

Question

Question:

need to replace my weld on trailer jack for my 20 ft triton boat trailer it has a 2 1/2 round pivot ring. which jack would be best

asked by: Scott

0

Expert Reply:

We carry a large selection of weld-on jacks that will fit your Triton boat trailer. I have attached a link that will tack you to the product page that has all of these jacks for your to review.

As for a jack that I recommend, I like the Square Pipe Mount Swivel Jack Weld On Sidewind, 7K, # TJDP-7000S-B. This jack has a 7,000 lbs lift capacity and has the 2-1/2 inch round tube swivel on the jack. Retracted the jack measures 17-1/2 inches and fully extended the jack will measure 29-1/2 inches tall.

expert reply by: Jared P

0

Answer 1

From the research that I did I found that Triton used Fulton jacks on a lot of their boat trailers. While this Fulton Round, Snap-Ring Swivel Marine Jack, part #FTJ120W0301, may not necessarily be the exact same one that is on your boat trailer it…

view full answer...

Answer 2

Triton boat trailers are usually equipped with a side-frame-mounted swivel jack like the 1500-lb-rated Fulton jack #FXPD15L, which is a bolt-on design with dual wheels. The highest-rated wheeled jacks of this type have a 1600-lb rating, like the…

view full answer...

Answer 3

The inside diameter of the snap ring is the crucial measurement. If your existing snap ring has a 2-5/16 (2.3125) inch inside diameter which is typical for a snap ring jack, the Fulton #F1410050149 snap ring swivel jack you'd looked at would work…

view full answer...

Answer 4

I think the Square Pipe Mount Swivel, part #TJDP-7000S-B would be a good choice for you. It has the 8,000lb support capacity which is one of the highest we offer, and is welded to the trailer frame.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...