Can Titan Model 10 Actuator be Locked Out When Backing Up

Question

Question:

is there a way to lockout the model 10 actuator for backing up when you are using the one for drum brakes

asked by: Mike S

0

Expert Reply:

You can pretty easily add an electric lockout to the Titan Model 10 actuator part # T2478100. For that all you would need is the part # T4748800. This will then allow you back up a hill without the brakes locking up.

expert reply by: Jameson C

0

Answer 1

The best trailer coupler lock for your Titan Model 10 Brake Actuator #T2478100 is the Blaylock EZ Lock Trailer Coupler Lock #BLTL-33-40D because it locks your actuator with a stainless steel padlock that has a hardened steel shackle and busting…

view full answer...

Answer 2

Go ahead and email me back with the picture of what you have and I can see if we can help. Worst case scenario you'd have to replace the coupler.

view full answer...

Answer 3

Begin by removing the master cylinder cap and fill the reservoir to three quarters full with DOT-3 brake fluid. DO NOT allow brake fluid to contact painted surfaces since it will damage the finish. Wipe up any spills immediately and wash the area…

view full answer...

Answer 4

You are correct. Other than how they are made, the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR and the #DM14793-81 have the same ratings and will work the same. There is no pro or con to either, so…

view full answer...

Answer 5

Personally I prefer the Demco Trailer Coupler #DM14976-52 with the composite handle over the Coupler #DM15791-81 with a metal handle. I feel it is easier to operate as it does not have the safety latch like you get on the metal handle. Since most…

view full answer...

Answer 6

Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up because…

view full answer...

Answer 7

No, you'll need to access the master cylinder from the rear of your Titan (now Dexter) Model 10 disc brake actuator. To replace it use the Replacement Master Cylinder Assembly #T4749501042, and I have linked a video below which shows how to do…

view full answer...

Answer 8

I am not aware of any Titan Surge Brake Actuators having an available manual lockout for them. It is possible to convert some of the Titan Zinc-Plated Brake Actuator #T2477600 to an electric lockout. To do this you will need the Solenoid Valve for…

view full answer...

Answer 9

For the bunks I recommend using two sets of the 5' CE Smith Carpeted Bunk Boards #CE27820, or you'd like to get your own wooden boards you can wrap them in Marine-Grade Carpeting #CE11349. To install the boards, you will need a pair of…

view full answer...

Can Titan Model 10 Actuator be Locked Out When Backing Up

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching