Can Master Cylinder be Accessed From Front Of Titan/Dexter Model 10 Disc Brake Actuator
Question:
Hello I have a titan 10 disc brake actuator, with weld on unit. Can I access master cylinder from the front. I notice there is a small opening underneath the rear of the actuator to possibly disconnect the brake line connection.
asked by: Edwin R
0
Expert Reply:
No, you'll need to access the master cylinder from the rear of your Titan (now Dexter) Model 10 disc brake actuator. To replace it use the Replacement Master Cylinder Assembly # T4749501042, and I have linked a video below which shows how to do so, and accessing/installing it from the rear of the actuator.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Replacement Master Cylinder Assembly for Dexter Model 10 and Model 20 Brake Actuators - Disc
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Master Cylinder
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Surge Brake Coupler For Aluminum Boat Trailer With 10,000LB Coupler
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Dimensions of Replacement Damper for Model 20 Actuator
- Q&A: How to Replace the Shock on a Titan Model 10 Surge Brake Actuator
- Q&A: Will The Kodiak Disc Brakes Kit # KOD49FR Fit In EZ Loader Trailer With 3,700LB Axle?
- Q&A: Replacement Titan Master Cylinder that is Stamped 23744
- Q&A: Is There a Installation Video That Will Help With Replacing Shocks On Dexter Model 10 Surge Actuator
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground
- Article: Trailer Tire Sizing
- Article: Trailer Couplers
- Article: How Much Does a Boat and Trailer Weigh?
- Article: 2023 Best Gifts for Haulers & Towers
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Wiring Diagrams