Can Atwood Carbon Monoxide and Propane Gas Alarm be Used in Place of a Safe-T-Alert Alarm

Question

Question:

I have to replace my Safe-T-Alert CO and Propane Gas Alarm, Model 25-741 cant find it . Will the Atwood CO and propane Detector Work?

asked by: David R

0

Expert Reply:

The Atwood CO and propane gas detector # AT36681 is pretty much a universal fit item so you can use it. Be sure to position it so that it is no more than 18 inches up from the ground since propane gas is heavier than air. I have included a link to the installation instructions for you.

expert reply by: Michael H

0

Answer 1

The RV Propane Gas and Carbon Monoxide Detector #RS34FR will work in place of your Safe-T-Alert 35-742 alarm. This alarm is 4-1/4" long x 2-5/8" wide x 1/2" thick and comes with 2 mounting brackets. The smaller bracket is 5-3/4"…

view full answer...

Answer 2

It sounds like your Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 is hooked up properly and is getting power. The code you hear is like you said a fault code in this case because of the audible tone. I recommend replacing it. The…

view full answer...

Answer 3

For your BBQ or Grill you will want the MB Sturgis Quick Disconnect Propane Hose for Small Appliance - Disposable Cylinder Port - 10' #100476-120-MBS. This is the best option we have for the fitting on that grill. We also have 4 foot hose…

view full answer...

Answer 4

In order to connect your Coleman appliance using the MB Sturgis Quick Disconnect Propane Hose #100476-120-MBS, you're going to need to use a T-Fitting like the MB Sturgis #103613-MBS. You'll then simply connect this hose to the…

view full answer...

Answer 5

Your quick disconnect was designed for appliances like a grill or stove to be used. Certain grills do have a different connection that requires more power as your Coleman Roadtrip may. Based on some research there are many videos that show how to…

view full answer...

Answer 6

Two power supplies are needed for the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 because if one were to fail it allows the other to act as a backup in case of a gas leak during the power outage.

view full answer...

Answer 7

The Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 has three wires though you only need to use two of them - a red for power and black for ground. The other red wire is for an optional back-up power source which is not necessary for…

view full answer...

Answer 8

The Atwood 2001 Protechtor you have is for detecting just propane whereas the part #AT36681 detects propane and carbon monoxide.

view full answer...

Answer 9

I tried finding information on the blinking green light on your Atwood Series 2001 LP Gas Detector but was unable to find anything that mentioned a blinking green light. The Atwood Series 2001 LP Gas Detector you have is no longer available which is…

view full answer...

Answer 10

The Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 will be an excellent replacement for the ProTECHtor LP Gas Detector. The Atwood RV Carbon Monoxide and Propane Gas Detector has a seven year life span which is pretty standard. The…

view full answer...

Answer 11

The trim ring is not available, but the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 can be mounted quite simply without it. I attached a page from the directions which shows how this is done; you simply remove the bezel from the…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Can Atwood Carbon Monoxide and Propane Gas Alarm be Used in Place of a Safe-T-Alert Alarm

Continue Researching