Does Pack'Em Expansion Pack PK-OP2 Come with Tower Mounts

Question

Question:

Is the mounting bar supposed to come with this? I did not get it with my order

asked by: Brian

0

Expert Reply:

The # PK-OP2 is designed to fit the part # PK-BM to complete the rack. It's an expansion rack which is why it does not come with the bars needed.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

We have the Complete RV Cleaner Kit #BE57VR which comes with everything needed to efficiently clean your RV as well as protect it. It comes with a bug remover, a black streak remover, a carpet cleaner, awning cleaner, and a wash and wax kit plus a…

view full answer...

Answer 3

The Brophy 5 Slot Tool Rack for E-Track - Black Powder Coated Steel #ETTH is 24 inches long edge to edge. The inner diameter of each slot is 2 inches and the fittings that mount to your E-Track are 16 inches on center. I've attached a…

view full answer...

Answer 4

Trailer jacks do sometimes fail even when they are being used under their capacity so while it's a bummer that yours did I wouldn't say you did anything wrong and maybe just had some bad luck with yours. For a replacement I really…

view full answer...

Answer 5

The E-Track has slots that have a length of 2.45-inches and a width of .58 inches. See attached diagram.

view full answer...

Answer 6

Due to the importance of a properly functioning break away system, it would be best to leave the existing break away battery in place and add an additional battery for powering the jack. A standard automotive or small deep-cycle 12 volt battery…

view full answer...

Answer 7

I spoke with my contact at RackEm regarding the ability to upgrade your existing 2 Trimmer System #PK-6S-6S2 to a 3 trimmer setup. He stated that an additional #PK-6S2 will physically bolt to your existing units, but he does not recommend doing…

view full answer...

Answer 8

The Pack'Em Racks #PK-6-OP1 themselves measure 46 inches. From the top mounting holes to the top of the racks they measure 36 inches. See attached picture.

view full answer...

Does Pack'Em Expansion Pack PK-OP2 Come with Tower Mounts

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching