Availability of a Spool Roller Assembly Without the Roller

Question

Question:

Is the spool roller assembly CE32100G available without the rubber roller?

asked by: Steve M

0

Expert Reply:

The closest thing that we carry to the roller assembly # CE32100G at this time is the Panel Bracket # CE10300G. This does not include the shaft or the end caps, so you will need the Roller Shaft with Pal Nuts # CE10721A as well.

expert reply by: Jon G

0

Answer 1

The majority of the weight of your boat should be supported by the bunk boards or by roller bunks. When the article referenced rollers it did not mean keel rollers. Keel rollers like the #CE10401G can hold the weight of the boat when loading and…

view full answer...

Answer 2

We don't offer a flat roller assembly, but the 5 inch #CE10401G assembly has a roller that's more flat that might work well for you. The flatter profile would spread more of the boat's weight out over a larger area.

view full answer...

Answer 3

The Hand Winch Strap with Safety Hook part #DL24242 is the same as the 24240 which is 2" wide.

view full answer...

Answer 4

Transom savers install by having one end attach to the lower section of your outboard motor and the other end goes to some point on the trailer. Typically a roller. The CE Smith Spool Roller Assembly part #CE32100G would work well for this.

view full answer...

Answer 5

When it comes to replacing the spool roller on The CE Smith Offset Spool Roller Assembly for Boat Trailers - Galvanized Steel w/ Black Rubber - 4 inch #CE32110G The Yates Bow Roller for Boat Trailers - TPR - 4 inch Long - 1/2 inch Shaft - Black…

view full answer...

Answer 6

I reached out to my contact at CE Smith and unfortunately they were unable to provide a weight capacity of the #CE32100G you were looking at. Another option that I know will work is adding the CE Smith Roller Bunks for Boat Trailers - 6 Rollers…

view full answer...

Answer 7

First, roller with bracket #CE32100G is not going to work because the mounting holes on it are spaced 3 inches apart on center so it would be too wide. It measure approximately 2-1/2 inches from the bottom of the bracket to the center of the shaft.…

view full answer...

Answer 8

I went out to the warehouse to measure the internal width of CE Smith roller #CE32110G. It measure 1-7/8 inches. I have included a picture showing this measurement for you.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Availability of a Spool Roller Assembly Without the Roller

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching