Hitch Recommendation for 1992 GMC Sierra SLE with Step Bumper

Question

Question:

I am looking for a hitch recommendation for my 1992 GMC Sierra SLE pickup with the 6-1/2 foot bed and an aftermarket step bumper. The step bumper does not appear to be the deep type as it only measures 6-7inch deep. I still have the original size spare tire and would like to keep it in the original mount location. I have looked at and read some of the references for the 75033, 41524, and 41525 models.

asked by: Cecil

0

Expert Reply:

For your 1992 GMC C/K with a step bumper we have the Curt hitch part # C14081 which is a confirmed fit. This hitch requires you to temporarily lower the spare to install it but you can then reinstall it once the hitch is installed.

expert reply by: Jameson C

0

Answer 1

I went out to the warehouse to take some measurements of Curt trailer hitch #C14082. I made a picture showing the measurements for you. The bolt holes, starting from the one furthest forward on the vehicle, measures 2-3/4 inches to the center of the…

view full answer...

Answer 2

According to my contacts at Curt Manufacturing, if the spare tire on your 1991 GMC pickup is the stock size, the spare tire might need to be slightly repositioned toward the front of the truck. This is a simple process. Remove spare, and install…

view full answer...

Answer 3

For your Big Tex 90PI trailer, I recommend checking out the: -RC Manufacturing T-Series Trailer Tongue Tool Box #350980. This toolbox has a cargo capacity of 2.6 cubic feet, measures 30" long x 14-1/2" tall x 14-1/2" wide, and is…

view full answer...

Answer 4

Yes. I've linked a picture of a Chevy C Series with the under-mounted spare tire to show you, but the Curt #C14082 will work with the stock spare tire mounting location on your 1971 C Series pickup and you won't need to make any modifications…

view full answer...

Answer 5

Based on your information, I recommend the Draw-Tite Class IV Ultra Frame Hitch, Item #41901, which is a confirmed fit for your 1997 Chevrolet C/K Series Pickup with standard bumper. This hitch is specially designed for heavy-duty towing with a…

view full answer...

Answer 6

Yes, the Curt trailer hitch part #C14081 that you referenced does fit a 1999 Chevy C3500 dually crew cab. The picture I attached shows a review where someone has installed the hitch on a similar 1999 Chevy C Series.

view full answer...

Answer 7

The frame on your 1994 Chevy C/K series truck indicates that it is NOT a cab and chassis model (which normally have narrower frames) so you can use hitch #41901. I have included a link to the installation instructions for you. I also recommend…

view full answer...

Answer 8

The hitches that are listed for the 1998 GMC trucks with 34 inch frames are the ones that are designed to fit the cab and chassis models. The #C14081 that you referenced would work well on your truck with a 37 inch frame since it is not a cab and…

view full answer...

Answer 9

We don't have any hitches that are confirmed to fit on the CUCV M1008 military truck, but from what I was able to find out is that it's a version of the Chevy C/K series trucks that were manufactured for civilian use. You may be able to use…

view full answer...

Answer 10

The measurement from the top of the mounting bracket down to the top of the receiver tube measures 5 inches. Curt trailer hitch #C14082 is a custom fit hitch designed to fit the following vehicles: 1973 - 2000 Chevrolet C/K Series Pickup Cab and…

view full answer...

Answer 11

I'd recommend the Curt Class IV hitch, part #C14081. When installed, the hitch will sit pretty tightly to the underside of the rear bumper, as would the Draw-Tite #41901 you looked at, but the Draw-Tite model only fits the long bed model truck.…

view full answer...

Answer 12

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

view full answer...

Hitch Recommendation for 1992 GMC Sierra SLE with Step Bumper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching