Does Access Tonnosport Tonneau Cover have a Weight Capacity for Snow

Question

Question:

HOW MUCH WEIGHT WILL IT HOLD SNOW

asked by: JOHN

0

Expert Reply:

While there isn't an official weight capacity listed for the Access Tonnosport Tonneau cover # A22010339 Access does have the following statement regarding snow:

"Our roll-up tonneau covers have been tested under all weather conditions and can endure even heavy mountain region snowfalls."

Despite this it would still be a good idea to brush off snow if at all possible.

expert reply by: Michael H

0

Answer 1

The Yakima FullBack 2 Bike Rack #Y02634 doesn't have any specific instructions for your 2013 Hyundai Tucson. It appears you simply need to uninstall the lower hooks first and with some slack in the hooks you will remove in the same way they were…

view full answer...

Answer 2

I am assuming that you are speaking of the installation connector for a brake controller. It is located on top of the white box on the firewall behind the emergency brake pedal. To install your brake controller, you will also need a Wiring Adapter,…

view full answer...

Answer 3

The adapter part #THXADAPT9 is specifically designed for your situation where you are trying to fit a Thule Echelon onto an aero shaped crossbar like what you sent in a picture of.

view full answer...

Answer 4

For your 2015 Starcraft camper I recommend taking a look at the Ultra-Fab Power Twin II Electric Stabilizer #UF39-941705, which will work so long as your trailer has a frame between 48" to 80" wide. It has a 6,000 lb capacity when the legs…

view full answer...

Answer 5

We have numerous racks that are rated for use behind an RV or trailer that would work for you. A rack with 4 inches of clearance probably will not work. The regular XC, #S64650, measures 10-1/2 inches from the center of the hitch pin hole out to the…

view full answer...

Answer 6

I think you are asking about a trailer jack for your Jayco popup. If so we have just what you need. For an a-frame camper I recommend a jack like part #TJA-5000S-B. This is a sidewind jack that has a 5,000-lb capacity and has a 15-5/8 inch lift. This…

view full answer...

Answer 7

You can wire a license plate light like part #LPL55CB without running wiring up to the front of the trailer. You simply attach the white wire with the ring terminal to a clean, bare metal surface like the trailer frame, and then attach the black wire…

view full answer...

Answer 8

The modern day size for a 20.5 x 8 x 10 sized tire is 205/65-10. Based on this information, I recommend The Kenda Loadstar Bias Trailer Tire Item #AM1HP56. It is a top-quality bias tire that is great for all terrains and provides a smooth ride. It…

view full answer...

Answer 9

Thank you for the photo; from that it looks like you have a 4-point hinge (like in the accompanying photo I added) and we do have a cover, the Vent Cover for Jensen Trailer Roof Vents - White #61628 which may work for you. If you have an older vent…

view full answer...

Answer 10

I have spoken with Lippert about the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817 in they past and they informed me that the most important aspect is that the battery/batteries are sufficiently charged, between 12.4…

view full answer...

Answer 11

The BAKFlip MX4 Hard Folding Tonneau Cover #BAK48122 is a confirmed fit for your 2018 GMC Sierra 3500 long-bed and when folded up completely the cover's smallest panel (nearest the cab) will be all that takes up bed space. So if you measure…

view full answer...

Answer 12

To adjust a Weight Distribution system on your 40 foot diesel pusher motorhome, I recommend making sure you air bags are inflated to the level you believe needed for your trailer to ride level. Then you can make adjustments to the head angle and…

view full answer...