Tall Fifth Wheel Stabilizer Availability

Question

Question:

I purchased a 5th wheel hitch stabilizer however it is too short. Do you see extensions for it. It was the King Pin brand

asked by: Tammie C

0

Expert Reply:

We do not carry that brand nor do we carry extensions for the stabilizers. You might just need to go with a taller stabilizer. The tallest one we have is the part # UF19-950500 which is adjustable up to 55 inches.

expert reply by: Jameson C

0

Answer 1

Since you have the steel tripod stabilizer, #UF19-950500, you would need the steel extensions #UF19-950002. Like you said, the extensions are 8 inches long. There are a total of 3 extension pieces included and each of those is 8 inches long.

view full answer...

Answer 2

The Ultra-Fab 5th Wheel King Pin Tripod Stabilizer part #UF19-950200 would be best for harsher environments. The Ultra-Fab 5th Wheel King Pin Tripod Stabilizer part #UF19-950600 has a black coating which will also resists rust but if this coating…

view full answer...

Answer 3

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 9

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 10

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Tall Fifth Wheel Stabilizer Availability

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching