What Type of Steel is Used in the Metal Loom Clamp A0500

Question

Question:

The Kodiak Brake line kit uses A0500 Metal Loom Clamp - 1/2, is this stainless steel, that wraps around the rubber?

asked by: Rob T

1

Helpful Expert Reply:

The wire loom part # A0500 is a zinc-coated steel. The zinc coating fights rust to prevent corrosion.

expert reply by: Jameson C

1

Answer 1

What you are probably seeing is a brake caliper that has 1 inlet from the actuator and 2 bleeder screws. This is because the calipers can be mounted on the left or right side so you will always have a bleeder screw that is pointed up. This is the one…

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 3

The Demco Hijacker Autoslide 21K #DM8550038 weighs approximately 305-lbs. The head of this hitch weighs around 70-lbs and can be removed to help make moving and installing this 5th wheel hitch a little bit easier.

view full answer...

Answer 4

Hey Daniel thanks for all the questions! One of them is going to be pretty easy but also disappointing, every hitch for your 2019 Toyota Sienna is going to require the panel to be removed, trimmed, then reinstalled. This is actually not as hard to do…

view full answer...

Answer 5

Your wheels are most likely the 5 on 4-1/2" bolt pattern but the only way to verify is by measuring the hub as they could have been changed in the past 25 years if you are not the original owner. We do have the Westlake ST205/75R14 Radial…

view full answer...

Answer 6

There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to change…

view full answer...

Answer 7

The price for the 1/2" Metal Loom Clamp #A0500 is for a single clamp. We do have the Clamp Kit #PT43VR which includes (20) 1/4", (8) 5/16", (6) 3/8", (4) 1/2", and (4) 5/8" clamps if you are going to end up needing a…

view full answer...

Answer 8

The Atwood couplers have been discontinued for a bit so you'll be hard-pressed to find any replacement parts for them. We don't have any replacement parts for them anymore so I recommend just replacing the whole coupler with something…

view full answer...

Answer 9

We currently have 3 different trailer jack support plates. I have included other dimensions in the included photos except for #BDSPB50 which was not available. #DL22763 is 1/8 inch thick. #BD003135 is 1/8 inch thick. #BDSPB50 is 1/8 inch thick. The…

view full answer...

Answer 10

For your 2017 Toyota Sienna, the best ground clearance will be the Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #76112 which will give you a ground clearance of about 9-1/2 Inches. If you need the smaller 1-1/4 inch…

view full answer...

What Type of Steel is Used in the Metal Loom Clamp A0500

Product Page this Question was Asked From

Continue Researching