Availablility of Tire Pressure Monitor System and Extra Sensors for Expansion

Question

Question:

Do you carry extra TPMS sensors?

asked by: Brent

0

Expert Reply:

We have the TireMinder RV Tire Pressure Monitoring System for Smartphone - Signal Booster - 4 Transmitters # TPMS-APP-4. This system uses your smartphone for monitoring. I've attached a review video for you to see functions. For more sensors we have the 6 transmitter # TPMS-APP-6. Either system does have extra sensors available with the brass # TM-2BRASS and the aluminum # TM-2ALUM. The software can track up to 22 tires.

expert reply by: Jason S

0

Answer 1

Yes, the Internal Tire Sensor for TireMinder TPMS #TM36FR will work with your TireMinder Smart TPMS for RVs like part #TPMS-APP-4. According to TireMinder the internal sensor is compatible with all of their kits aside from the Solar Powered TPMS kit…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

Yes, you can swap out your cap sensors for internal sensors and they will work with your current TST-507-RV-4 system. We offer the internal sensors individually with part #TST-507-INT-S1. Definitely a good idea if you don't want to have to worry…

view full answer...