Will the Edge Insight CS2 Gauge Display Fit a 2003 Ford E-450 Van

Question

Question:

Will the edge insight cs2 work on a 2003 ford e450 super duty with the 7.3 diesel and the code is HPI4?

asked by: Jeff C

0

Expert Reply:

The Edge InSight # EP84030 is a comprehensive gauge display that will work on any vehicle with an OBDII port which does included your 2003 Ford E-450 van. Please note this is not a programmer so it cannot change the tuning of the motor or anything. It can read and clear fault codes.

expert reply by: Michael H

0

Answer 1

Yes, the Edge Insight CS2 Comprehensive Gauge Display part #EP84030 will read and display boost levels on your 2001 Ford Excursion with 7.3 PowerStroke engine. There won't be any additional sensors needed for this either as the device comes with…

view full answer...

Answer 2

I spoke with my contact at Edge and he confirmed that the Edge Insight CS2 #EP84030 will work with your 2001 Ford F-650 Super Crewzer. Although keep in mind that this monitor is specifically designed for the F-350, so while it will work, some of the…

view full answer...

Answer 3

Typically the OBD-II port on any vehicle is located to the left of the steering column under the driver side dash. It could be in plain sight or it could be tucked up somewhere. Some vehicles will even have a cover over it labeled "OBD-II"…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 6

As long as your 2002 Ford E-450 chassis is equipped with a factory 7-Way or 4-Way at the rear bumper then there should be a brake controller plug-in port behind the dash to the right of the steering column. If this is the case on your E-450 then to…

view full answer...

Answer 7

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 10

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the SAE A P2 DOT 14 and would be what you'd need.

view full answer...

Answer 11

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 12

I recommend going with the Curt Trailer Hitch Receiver #C11424 for your 2017 Hyundai Elantra as long as it's a Sedan (excluding the Sport edition). I like the Curt hitches because they tend to have a thicker powder coat which helps to protect…

view full answer...

Will the Edge Insight CS2 Gauge Display Fit a 2003 Ford E-450 Van

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching