Steering Stabilizer Recommendation for 2012 Ford E-450 Motorhome Class C

Question

Question:

I have an 2012 E450 Sunseeker class C motorhome and I would like to know the model of the mounting kit for Roadmaster Reflex Steering Stabilizer for Class C Motorhomes Thanks

asked by: John B

0

Expert Reply:

The correct steering stabilizer for your 2012 Ford E-450 motorhome Class C depends on the size engine your RV has. If it is a V8 you would need the part # RM-RBK2-RSSC. If it is a V10 instead you would want the part # RM-RBK24-RSSC.

expert reply by: Jameson C

0

Answer 1

On the 2003 Ford E-450 Class C with OEM steering damper you would use #RM-RBK24-RSSC that you have referenced and you would the included brackets and hardware for installation. The new steering stabilizer does not use the same factory brackets. It…

view full answer...

Answer 2

The proper Roadmaster steering stabilizer for your 2005 Ford E450 V-10 Class C Motor Home is the Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class C Motor Homes, part #RM-RBK24-RSSC. This will include the steering stabilizer,…

view full answer...

Answer 3

The difference between the Roadmaster Reflex steering stabilizers is how they connect to the brackets that fit onto the RV. Take a look at the pictures I attached and you can see the difference between the ends of them. #RM-RSSA has eyes on both…

view full answer...

Answer 4

In regards to steering and keeping the wheel centered, the Roadmaster Exact Center Steering Stabilizer part #RM47MR will work great for this on a 2022 Ford E-450 Chassis. The stabilizer is basically a spring that returns the wheel to center when…

view full answer...

Answer 5

I checked with Roadmaster, and the correct fit for your 2021 Ford E450 Class C RV is the Roadmaster Exact Center Steering Stabilizer #RM47MR.

view full answer...

Answer 6

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 7

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 11

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 12

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Steering Stabilizer Recommendation for 2012 Ford E-450 Motorhome Class C

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching