Replacement Lens Cover for Trailer Light PM-108-15

Question

Question:

I am needing a couple of replacement lens for my camper, I took one off and and is show PM-108-15. Is that the same as the 108-15R?

asked by: JoAnna B

0

Expert Reply:

The red replacement lens is indeed # 108-15R. If you need an amber lens then you'll want # 108-15A.

expert reply by: Charles S

0

Answer 1

We have exactly what you need. For the amber lens light you would want the Oval Clearance Light part #MC38AB and then for the red light you would want the Peterson Red Oblong Clearance Light part #423000.

view full answer...

Answer 2

In place of your Atwood MPD 93756 I recommend the Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU - 16" x 16" Door Item #FR98SR. It has similar dimensions at 12-5/8L x 12-13/16W x 19-3/16D so you'll…

view full answer...

Answer 3

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 4

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Answer 5

I recommend replacing an entire ladder if it's damaged. You'll want to find a replacement based on the height. Such as the Stromberg Carlson #LA-401 that is 99-1/2 inches tall. They can be cut shorter to customize the length if needed.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 9

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 12

Between the Kuat Transfer part #KU74FR and the Swagman Chinook part #S64683 I would go with the Transfer mainly because it only touches the bikes at the tires whereas the Chinook grabs the frame of the bikes when securing. Swagman and Kuat are both…

view full answer...

Replacement Lens Cover for Trailer Light PM-108-15

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching