Can a Crossover Toolbox be Mounted with Thule Ladder Rack # TH500XT on a 2016 Ram 1500

Question

Question:

Does this latter rack make it possible to also have a toolbox that mounts on the rails?

asked by: Luke

0

Expert Reply:

To use Thule ladder rack # TH500XT with a crossover toolbox you would have to move the front part of the ladder rack rearward on the bed so the area the toolbox needs is clear. There isn't a way to mount a toolbox on top of the ladder rack brackets.

expert reply by: Michael H

0

Answer 1

The Erickson Over-The-Cab Truck Bed Ladder Rack part #EM07707 is designed to work with chest style toolboxes such as the DeeZee Red Label Truck Bed Toolbox part #DZ8546B. In order to use this ladder rack with a crossover style toolbox like the…

view full answer...

Answer 2

The Evo fit kit you mentioned will not fit with the 480 kit that was phased out by Thule. Best option for your 2017 Toyota Tacoma Double Cab will be an all new roof rack like with the WingBar Evo part #TH711420, #TH710501, and #TH145107.

view full answer...

Answer 3

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the…

view full answer...

Answer 6

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 10

Hey Shannon, thanks for reaching out! Sounds like you're looking for the Thule Xsporter Pro #TH500XTB-THXK3 for your 2008 Toyota Tacoma with the Deck Rail System. This is adjustable up and down as well as along the Deck Rail System so you get the…

view full answer...

Answer 11

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Can a Crossover Toolbox be Mounted with Thule Ladder Rack # TH500XT on a 2016 Ram 1500

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching