How Many Sway Control Units for a 19 Foot Camper Trailer

Question

Question:

Do I need to sway bars and a 19 foot camper trailer

asked by: George C

0

Expert Reply:

For towing a 19 foot camper like yours a single friction sway control unit like part # 17200 would be adequate. We typically only recommend a second one when the trailer is over 26 feet in length.

expert reply by: Jameson C

0

Answer 1

The 2018 Land Rover Discover has an integrated air system that is designed for trailer stability so they recommend not using the Weight Distribution hitches because their integrated system is designed to help with vehicle sag. You can use your…

view full answer...

Answer 2

No. The 7-Way end in the #47405 adapter is made for the North American style of 7-Way round pins. A European 7-Way, see picture, has separate turn signals and brake lights and a circuit for fog lamps. The tail lights are also separate. You would need…

view full answer...

Answer 3

Since your light plugs into a 7-way round you'd actually need the opposite adapter than the #F77R. Which for that you'd just need the part #PK12728.

view full answer...

Answer 4

Based on your pictures, you need a 7-way blade adapter to 7-way round trailer end. I have just what you need. I recommend the Custer Trailer Connector Adapter w/ Dust Cover - 7-Pole Round Pin to 7-Way Blade #F77R.

view full answer...

Answer 5

That is definitely a Euro style 7-way that you submitted a picture of. You would want to remove this connector and go with a standard 7-way blade connector like part #PK11893. The best way to do that is to use a circuit tester like our #PTW2993 to…

view full answer...

Answer 6

There is a difference between a 7-way round and and 7-way rv blade connector. If you take a look at the accompanying photo, which is from our linked article on trailer wiring you can see that the connector on the left has blade-style pins while the…

view full answer...

Answer 7

The easiest way to go from a 7-way round connector to a 7-way flat would be to get a Trailer Connector Adapter part #HM47425. However, if you are looking for a more permanent solution you would need to remove your 7-way round connector and wire up…

view full answer...

Answer 8

We have an adapter that was designed specifically for that with the Trailer Connector Adapter - Vehicle End - 7-Pole Round to 7-Way Blade #HM47425. This will plug into your vehicle's 7-way round and give your trailer a 7-way blade connector.

view full answer...

Answer 9

What you have on your 1993 Ford F150 is a round 7-way, and it sounds like your travel trailer has a blade style 7-way. All you need is the correct adapter and you would be good to go. For that you would want the Trailer Connector Adapter #HM47425.…

view full answer...

Answer 10

We do have the Pollak Trailer Connector Adapter #HM47425 which is designed to plug into a 7-way round and give you a 7-way blade connector. This would work well for you.

view full answer...

Answer 11

The Curt Echo Wireless Trailer Brake Controller #C51180 is compatible with 7-Way blade style sockets, but if you use the Trailer Connector Adapter #HM47425 it should make the Echo compatible with the 7-Way round socket on your semi. Below is a list…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...