Vertical Capacity of Curt C48550 Lunette Ring- Flat Plate Mount

Question

Question:

What is the vertical capacity for this style of ring. The 42,000 lbs is the gross trailer weight correct? Currently I have the forged eye that mounts in the channel 3inch 24,000 lb but didnt realize how low the vertical capacity is.

asked by: Gary S

0

Expert Reply:

The Curt # C48550 Lunette Ring has an 8400 lb vertical capacity when fastened with the included 5/8 inch bolts. The gross weight capacity is 35,000 lbs.

expert reply by: Mike L

0

Answer 1

Due to the heavy duty nature of the lunette style pintle setups there isn't a bushing available for the rings. The sway you are experiencing is most likely due to improper trailer loading. If you move as much of the weight of your cargo forward…

view full answer...

Answer 2

Lunette rings do come in more than one size. The linked page displays both 2-1/2-inch and 3-inch inner diameter. . Lunette ring accessory items are also shown on the other linked page. Weight capacities for lunette rings are substantial, ranging from…

view full answer...

Answer 3

The Ark Drop Down Corner RV Stabilizer Jacks - 33" #ARK77FR is the same as their part number: XODDS850BUS.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Yes, the Sleeve-Lock Trailer Coupler #CTA-196 will fit the channel bracket that comes with the Brophy Lunette Ring w/ 3-Position Adjustable Channel Bracket #BR43ZR. The bolt holes match as well when it comes to size and spacing so you'll be good…

view full answer...

Answer 11

Yes, they do. The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs item #F95FV will fit the dually and single rear models of the 2024 Ford F-350 4WD. These air bags have a 7,500 lbs capacity that will level out the rear end of your F-350…

view full answer...

Vertical Capacity of Curt C48550 Lunette Ring- Flat Plate Mount

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching