Dimension Of Fastway e2 Weight Distribution Shank

Question

Question:

Hi, I have a couple of questions and I appreciate your response: 1 What is the distance from the middle of hitch pin hole to the middle of adjustment holes for shank with part # FA92-02-4100? 2 Which shank, rated for 800# plus tongue weight, has the shortest distance from the middle of hitch pin hole to the middle of adjustment holes? Thanks!

asked by: Kaivan

1

Helpful Expert Reply:

The distance from the center of the hitch pin hole to the adjustment holes on the vertical part of part # FA92-02-4100 is 8 inches. I have attached a photo of the shank with the dimensions noted.

The # FA92-02-4100 shank would offer the shortest distance from the center of the hitch pin hole to the adjustment holes. It is rated for 1,200-lbs tongue weight has features 6-1/4 inches rise to 2-1/4 inch drop.

expert reply by: Jeffrey L

1

click to enlarge

Answer 1

Your weight distribution system uses a Shank #FA92-02-4100 that gives you a maximum 6-1/4" of rise and 2-1/4" of drop. I recommend using the Fastway Shank #FA92-02-4214. This will give you up to 10" of rise and…

view full answer...

Answer 2

Eight inches from the ground to the bottom of your weight distribution shank would be fine for most situations but like you've experienced turning into inclined driveways can cause it to drag. Your trailer must sit pretty low to call for…

view full answer...

Answer 3

The shank that comes with the Fastway e2 weight distribution systems rated for 1,000 lbs/10,000 lbs is part #FA92-02-4100. This shank does use the industry standard 1-1/4" adjustments so if you're needing something a little longer or…

view full answer...

Answer 4

If you need exactly a 4 inch drop (or even up to 5-1/2 inches), then you will want the Fastway e2 Weight Distribution Shank #FA92-02-4214, but if you need just a little more than that you will want #FA92-02-4315 which will give you up to a 9-3/4…

view full answer...

Answer 5

I went to our warehouse and checked the Replacement Head #FA94-02-1055 for Fastway e2 Weight Distribution Systems and found that it takes a hitch ball with a 1-1/4-inch diameter shank. You can use the link provided to view all 2-5/16-inch hitch…

view full answer...

Answer 6

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow, this figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

view full answer...

Answer 7

2013 and 2014 Dodge Ram Pickups use a different wiring harness than Rams from previous years. In the 2013 and 2014 models, the red stop light wire connects up above the gas pedal. The easiest way to install a brake controller into a 2013 or 2014…

view full answer...

Answer 8

The correct replacement hardware kit for your Fastway e2 4.5k system is the Replacement Hardware Kit for Fastway e2 Weight Distribution Head #FA92-02-9600. The Replacement Bolts for Equal-i-zer Weight Distribution Head #EQ90-02-9400 you asked about…

view full answer...

Answer 9

Having a ladder rack and a tonneau cover can be challenging because of the clearance each one needs. Looking at the hard cover, and the Erickson Over-The-Cab Truck Bed Ladder Rack #EM07707 you referenced I don't think that they would be…

view full answer...

Dimension Of Fastway e2 Weight Distribution Shank

Product Page this Question was Asked From

Continue Researching