Replacement Shank for 1,000 lb/10,000 lb Fastway e2 Weight Distribution System

Question

Question:

Cant find on Website the Shank only part for a Fastway e2 1000/10,000 weight distribution hitch

asked by: Rick

1

Helpful Expert Reply:

The shank that comes with the Fastway e2 weight distribution systems rated for 1,000 lbs/10,000 lbs is part # FA92-02-4100.

This shank does use the industry standard 1-1/4" adjustments so if you're needing something a little longer or taller I'm linking our selection of replacement weight distribution shanks for you to filter through.

expert reply by: Jon G

1

Rick

10/29/2021

Thanks Jon for quick response

Reply

Answer 1

The distance from the center of the hitch pin hole to the adjustment holes on the vertical part of part #FA92-02-4100 is 8 inches. I have attached a photo of the shank with the dimensions noted. The #FA92-02-4100 shank would offer the shortest…

view full answer...

Answer 2

Yes, the Fastway shank part #FA92-02-4100 that you referenced is compatible with all of the Equal-i-zer weight distribution systems including your #EQ37120ET. Fastway and Equal-i-zer are actually made by the same company but the shanks of most WD…

view full answer...

Answer 3

I went to our warehouse and checked the Replacement Head #FA94-02-1055 for Fastway e2 Weight Distribution Systems and found that it takes a hitch ball with a 1-1/4-inch diameter shank. You can use the link provided to view all 2-5/16-inch hitch balls…

view full answer...

Answer 4

Eight inches from the ground to the bottom of your weight distribution shank would be fine for most situations but like you've experienced turning into inclined driveways can cause it to drag. Your trailer must sit pretty low to call for your…

view full answer...

Answer 5

Your weight distribution system uses a Shank #FA92-02-4100 that gives you a maximum 6-1/4" of rise and 2-1/4" of drop. I recommend using the Fastway Shank #FA92-02-4214. This will give you up to 10" of rise and 7-1/4" of drop with…

view full answer...

Answer 6

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow, this figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

view full answer...

Answer 7

2013 and 2014 Dodge Ram Pickups use a different wiring harness than Rams from previous years. In the 2013 and 2014 models, the red stop light wire connects up above the gas pedal. The easiest way to install a brake controller into a 2013 or 2014…

view full answer...

Answer 8

The correct replacement hardware kit for your Fastway e2 4.5k system is the Replacement Hardware Kit for Fastway e2 Weight Distribution Head #FA92-02-9600. The Replacement Bolts for Equal-i-zer Weight Distribution Head #EQ90-02-9400 you asked about…

view full answer...

Replacement Shank for 1,000 lb/10,000 lb Fastway e2 Weight Distribution System

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching