Installing a Brake Controller on a 2014 Jeep Wrangler Unlimited

Question

Question:

I purchased the Jeep Wrangler Unlimited Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 AxleLooking for 2014 jeep wrangler unlimited brake controller plug in wiring harness

asked by: Larry

0

Expert Reply:

A brake controller will have to be hardwired into your 2014 Jeep Wrangler Unlimited because there isn't a brake controller harness made for it. Since you already have the brake controller you will just need installation kit # 5506.

The brake controller white wire connects to the negative battery terminal. The black wire will connect to the positive battery terminal via a 30-amp circuit breaker included with the # 5506 kit. The blue wire will connect to the back of the 7-Way connector in the 7 o'clock position. The red wire will attach to the cold side of the brake switch.

The brake switch is located above the brake pedal, often attach to the pedal arm. It is likely a white/brown wire but use a circuit tester such as # PTW2993 to test the wires. You need the one that only has power when the brake pedal is pressed and not when the head lights or turn signals are on.

expert reply by: Michael H

0

Answer 1

We do offer tow bar setups that can attach to the D-rings on the Warn Elite Bumper. Your will need to use a D-ring adapter to connect the tow bar. For the adapter you have the following options: 1" Thick D-Rings #RM-035-1 3/4" Thick…

view full answer...

Answer 2

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Installing a Brake Controller on a 2014 Jeep Wrangler Unlimited

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching