Roof Vent Recommendation for a Pleasant Valley Tear Trailer

Question

Question:

I have a pleasant valley tear similar to the silver streak lil guy. We would like to put in a roof vent it gets a lil warm inside. It is small 5x8 so almost all the roof area is curved. And it has a light in the middle. And super beautiful wood. I afraid to cut a hole in the roof for a vent because: dont know where the wiring for light is I would have to make sure a vent could work on curved surface I will have to move the light Do you have any suggestions for me? thanks

asked by: Beth G

0

Expert Reply:

For your small tear trailer I recommend a small, round 12 volt vent/fan, # VP-543SP. You may not have to move the light, it will limit the hole size needed, and the curved roof won't be a problem. The vent just needs to be connected to a 12 volt circuit for power and grounded to a clean metal surface. I have linked a video review of this vent for you.

expert reply by: Michael H

0

click to enlarge

Answer 1

I don't see any reason you couldn't use the Redline 2-Way Pop-Up Roof Vent with Garnish for Enclosed Trailers #9106-2756 in the metal window panels of your Ford Transit Connect. People install these on similar surfaces pretty…

view full answer...

Answer 2

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 3

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 4

The Go Power PWM Solar Charge Controller would actually not work for your Goal Zero Boulder 200 Briefcase Solar Panel #287-32409 as you're going to need a 20 amp controller instead. Instead you'll want to check out the: -Goal Zero 20 Amp…

view full answer...

Answer 5

The bracket that holds the lid of the Replacement Exterior Pop-Up Roof Vent #RV-626-062 is riveted to the vent so you'd likely have a hard time trying to remove it without damaging it. Removing the entire vent from the roof of your trailer would…

view full answer...

Answer 6

Yes, I have messed with the Redline 2-Way Pop-Up Roof Vent #9106-2756 on several occasions and you can open it easily from the outside of the trailer.

view full answer...

Answer 7

I've attached pictures showing the pretty much every dimension of the Replacement Exterior Pop-Up Roof Vent #RV-626-062. If you need any other measurements please reply back and I'll get them for you.

view full answer...

Roof Vent Recommendation for a Pleasant Valley Tear Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching