Tips for Installing Opti-Brite LED Work Lights on Outside of Enclosed Trailer
Question:
Would like to purchase two of these lights and install at top of ramp door on an enclosed trailer to light up the ramp entry. What are your recommendations to install and specifically, the best way to wire?
asked by: Les
Expert Reply:
As far as physically mounting the Opti-Brite work light # TLL60FB it has a bracket that you can just bolt directly to the mounting surface so that much is easy. Just be sure to use hardware that is appropriate for the mounting surface material.
Wiring on the other hand is just slightly more complicated. What I recommend is running the power wires for the lights to a switch, # PK34513. Then the power wire for the which will need to attach to either a trailer mounted 12 volt battery or the 12 volt circuit through the trailer connector.
For additional wire I recommend # 12-1-1, sold by the foot. And if you do not have wiring tools we have a handy kit, # HM51010, with various parts you will need for the wiring installation.
You will likely have to put holes in the trailer for the wiring to enter/exit. I recommend that after the wiring is run seal up the holes with some silicone # 0160297 to keep moisture and other stuff from getting into the trailer. But you don't have to do this.
Products Referenced in This Question
TremPro 644 Silicone Sealant - 10.1-Fl-Oz Cartridge - White
- Lubricants Sealants Adhesives
- Sealant
- Multi-Purpose Sealant
- 10.1 oz
- Flint Hill Goods
more information >
Hopkins Trailer Wiring Installation Kit
- Wiring
- Tools for Wiring
- Wiring Kits
- Installation Kit
- Hopkins
more information >
Pollak Light-Duty Toggle Switch - On-Off - 12 Volt - 10 Amp - 6" Wire Leads
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- 10 Amp
- Pollak
more information >
Product Page this Question was Asked From
Opti-Brite LED Work Light - Flood Beam - 720 Lumens - Black Aluminum - Rectangle - Qty 1
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Rectangle
- Pedestal Mount
- Flood Beam
- LED Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Shop: Opti-Brite LED Work Light - Flood Beam - 720 Lumen - Black Aluminum - Round - Qty 1
- Shop: Opti-Brite LED Work Light - Flood Beam - 897 Lumens - Black Aluminum - Round - Qty 1
- Shop: Optronics Utility Work Light - Rubber Housing - Incandescent - Round - Clear Lens
- Shop: Peterson PAR 36 Work Light w/ Mounting Bracket - Trapezoid Beam - Rubber Housing - Clear Lens
- Shop: Optronics Flexible LED Light Strip - Weatherproof - White - 17' Long
- Q&A: Can LED Trailer Lights be Added to Horse Trailer
- Q&A: Can Trailer Wiring Harness Power Wire be Connected to Running Light Wire Instead of Battery
- Shop: RV Exterior Lighting
- Shop: GloLight LED Trailer Clearance or Side Marker Light - Submersible - 6 Diodes - Round - Amber Lens
- Shop: Optronics LED Trailer Clearance or Side Marker Light - Submersible - 3 Diodes - Round - Amber Lens
- Video: Optronics Lights - Utility/Work Lights - TLL60FB Review
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Replacement LED Trailer Tail Lights and Recommended Utility Work Light
- Search Results: 344270kitw
- Search Results: vent
- Shop: Vehicle Lights
- Video: Pollak Light-Duty On-Off Toggle Switch Installation
- Video: Buyers Products Ultra Bright LED Flood Light Installation - Enclosed Trailer
- Search Results: 1156 led
- Search Results: 1156 led bulb
- Video: Optronics Trailer Lights A54GB Review
- Video: Opti-Brite LED Work Light Installation - 2013 Ford F-250 and F-350 Super Duty
- Video: Optronics Lights - Utility/Work Lights - TLL45FB Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Trailer Wiring
- Search Results: 7 pin pigtail
- Video: Pollak Wiring PK52249 Review
- Search Results: my account
- Q&A: What is Width of Mounting Bracket of Optronics Halogen Utility Light # QH16CTS