Replacement 5th Wheel Trailer Landing Gear Brackets
Question:
I dont know what type of landing gear Im working with, is there any dimensions on these brackets? Height, width, depth, thickness ? from what the picture shows it looks like its made of galvanized steel, that wouldnt be good for welding. is it made of galvanized steel?
asked by: Chris T
Helpful Expert Reply:
The Lippert landing gear bracket # LC113511 is 2" long x 3-1/2" wide x 4-1/2" tall just like # LG-Brackets. They are roughly 3/16 inches thick but that can vary some so a range of 1/8 to 3/16 inches would cover it. For the most part landing gear is all dimensionally the same which is why many of the parts are interchangeable amongst the different brands. You could go with either of the above part numbers and they would work.
Both are also raw steel, not galvanized, and are meant to be welded on. As you probably know, galvanized steel can be welded but it gives off toxic fumes and requires a skilled welder with galvanized welding experience. So that is why they make them from raw steel.
Products Referenced in This Question
Replacement Weld-On Mounting Brackets for Stromberg Carlson Landing Gear - Qty 2
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Continue Researching
- Shop: Fifth Wheel Hitch
- Shop: B&W Patriot 5th Wheel Trailer Hitch w/ Slider - Dual Jaw - 18,000 lbs
- Shop: Trailer Wiring
- Shop: Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole - Ford, GM, Dodge, Nissan w/ Factory Plug
- Shop: Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Shop: B&W Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches
- Q&A: How to Clear Out-of-Stroke Error Message on Lippert Ground Control System LC358590
- Search Results: pk11893~11932
- Shop: Suspension Enhancement
- Shop: Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Shop: Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 5,000 lbs - Qty 2
- Q&A: What to Do if Landing Gear Leg on Trailer is Bent
- Video: B and W Custom Base Rails Kit Installation - 2018 Ram 2500
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Q&A: Can Trailer Landing Gear Legs be Welded Directly to Frame
- Search Results: redline
- Shop: RV Roof Membrane
- Search Results: trailer axle flip
- Shop: Spare Tire Cover
- Video: Stromberg Carlson Trailer Jack LG-BRACKETS Review
- Search Results: anderson levelers
- Search Results: bearing buddy
- Q&A: What is the Difference Between etrailer 8,000 lb Landing Gear Sets
- Q&A: Bracket Dimensions of the etrailer RV Landing Gear System # RVLG-8HDL
- Shop: Truck Tailgate Lock
- Search Results: 010 042 00
- Search Results: door handle
- Article: Trailer Wiring Diagrams
- Q&A: Seal With Dimensions to Replace 171255UC
- Video: Choosing the Right Trailer Wiring