Replacement Strap and Anti-Sway Cradle Recommendation for a Thule Raceway TH9001

Question

Question:

Hi... I have the Thule 9001XT Raceway Trunk Mount 2 Bike Rack. I was looking for one strap and one anti sway cradle for it. Do you have those items? Thanks,

asked by: David

0

Expert Reply:

Yes we do. The correct replacement strap is part # 852-3006-001 and then the correct anti-sway cradle is part # TH8523486001.

expert reply by: Jameson C

0

Answer 1

The two parts you are looking at differ slightly in design/size and are actually for different bike racks. For example, the Replacement Anti-Sway Cradle #TH8523486001 is for Thule Raceway TH9001XT and TH9002XT while the Replacement Anti-Sway…

view full answer...

Answer 2

The correct replacement strap is part #852-3006-001 and then the correct anti-sway cradle is part #TH8523486001 for your Thule Raceway Pro part #TH9001PRO. Judging by the picture you submitted it looks like you have the correct straps. If it is cold…

view full answer...

Answer 3

If you need the straps that go along with the Replacement Anti-Sway Attachment for Thule Apex and Helium Aero Bike Racks #1500056128, the straps you need are the #852-3006-001 (1 replacement strap) or #TH534 (4 replacement straps). The straps along…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...