Quantity of Parts Included in Roadmaster Replacement End Bushing for Rear Anti-Sway Bar

Question

Question:

Hi, question for the Roadmaster sway bar bushing. I need to replace bushings on both sides of the sway bar. How many bushings I need to order? Does it come in pair? Thanks.

asked by: Allan

0

Expert Reply:

Good news, I can help you figure out how many bushings you will need.

According to the directions there are 4 # RM-205227-00 bushings included in the original # RM-1209-128 kit.

The replacement bushings # RM-205227-00 are sold in the quantity of 1, so you will need to order 4 to replace both sides of your original Roadmaster Rear Anti Sway Bar.

I have linked all the parts to the page for your convenience.

expert reply by: Jackie C

0

Answer 1

The retro-fit installation kit, #RM-590064-00, for the 2009 Freightliner Sprinter 2500 contains the following items: Four 10mm x 1.5 Locknuts Four 10mm x 1.5 x 25mm Hex Bolts Two Bushing Clamps Two 12mm x 1.5 x 140mm Hex Bolts Two 12mm x 1.5 x 55mm…

view full answer...

Answer 2

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 3

Hi Bob; since there is less stability at the rear of your 2013 Thor ACE 30.1 the rear anti-sway bar will have the greatest impact. The correct part for your motorhome is the Roadmaster Rear Anti-Sway Bar #RM-1139-146. It sounds like you plan on…

view full answer...

Answer 4

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 7

I found the online version of the install instructions for the Exact Center stabilizers like the #RM47MR. What's fun is that just when you think you have found the correct step to address your problem it tells you to continue to the next step.…

view full answer...

Answer 8

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 9

The Roadmaster Rear Anti-Sway Bar for Motorhomes #RM-1139-143 can use your factory u-bolts if they are long enough. If they are not, then Roadmaster recommends using the 7/8 inch diameter u-bolts that are longer (most likely the larger diameter due…

view full answer...

Quantity of Parts Included in Roadmaster Replacement End Bushing for Rear Anti-Sway Bar

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching