Will Timbren Rear Suspension Enhancement System Fit 2006 Toyota 4Runner

Question

Question:

I have 2006 Toyota 4 Runner 4WD 4.0 L with towing package. The orginal rear axle frame bump stop was too short about 2.5. I measured the top of the frame to the bottom of axle and it has about a little over 5 inches space. Picture of the top rear axle. Will TTORSEQ fit? Thanks

asked by: Rey

1

Helpful Expert Reply:

The Timbren Rear Suspension Enhancement System # TTORSEQ will work well for your 2006 Toyota 4Runner 4WD. These rubber springs will install in place of the factory bump stop and measure approximately 4-1/2 inches with the bracket.

The Timbren Suspension Enhancement System will help your vehicle ride level when towing or carrying heavy cargo. The weight capacity of the vehicle is not increased when using the # TTORSEQ system.

I have attached an installation video and the installation instructions for the springs # TTORSEQ for you. I also attached a help article on Timbren springs.

expert reply by: Victoria B

1

click to enlarge

Answer 1

We do offer a range of suspension enhancement kits for your 2006 Toyota Land Cruiser (if it is 4WD) and all can be seen using the link provided. The available options include rubber jounce springs and also adjustable air springs. Advantages of…

view full answer...

Answer 2

I wasn't able to determine the capacities of the OEM hitch on your 2021 Toyota 4Runner, the only references I could find was to the 500lb TW/5000lb towing capacity of the vehicle itself 'When Properly Equipped'. In the list of…

view full answer...

Answer 3

With a properly rated weight distribution system that is properly set up you should not need a Timbren. If you are still getting sag then one of three things is happening. Either you are just exceeding the towing capacity of your vehicle which is…

view full answer...

Answer 4

When it comes to products to install on your 2022 Toyota 4Runner that are low maintenance, look no further than the Timbren Kit #TTORSEQ. This installs in place of your OEM bump stop and can help with up to 6,000 lbs of weight (although it…

view full answer...

Answer 5

Those are very good questions and let's start with the capacities of both systems. The SumoSprings Solo Custom Helper Springs #SSR-612-40 has a 500 lb capacity and SumoSprings #SSR-612-47 has a 1,000 lb capacity, which means that is the highest…

view full answer...

Answer 6

I actually have a much better solution for your 2008 GMC Yukon XL. Suspension enhancement will give the rear suspension more support when towing, but a weight distribution system is actually the better solution. Not only will it give your rear…

view full answer...

Answer 7

Of the available choices, I prefer the SumoSprings #SS68DR which would provide up to 1400 lbs of additional support for your rear suspension which would work great to counteract the tongue weight of your travel trailer. Not only will the SumoSprings…

view full answer...

Answer 8

Between the 1,400 lb SumoSprings Solo Custom Helper Springs #SS68DR and the 1,800 lb Kit #SS78DR I recommend going with the 1,800 lb kit. These won't affect your daily drive but will offer the support you need when you are going Overlanding. If…

view full answer...

Answer 9

You are right on with my recommendation. For rear suspension enhancement for your 2005 Toyota 4Runner towing a single axle Jayco camper weighing around 2750 unloaded the SumoSprings #SS78DR is what I recommend. SumoSprings are a lot softer than other…

view full answer...

Answer 10

With an unloaded ride on your 2006 Toyota Sequoia, there will be approximately 1 inch of space between the axle and the bottom of the SumoSprings Solo Custom Helper Springs #SS68DR. These are a light capacity helper spring, and if you are off-road…

view full answer...

Answer 11

For suspension enhancement on your 2021 Toyota 4Runner limited I recommend the SumoSprings Solo Custom Helper Springs - Rear Axle #SS68DR. These are maintenance-free and will help keep you level. They use progressive load control so they springs…

view full answer...

Answer 12

The only suspension enhancement product available that is confirmed to fit the rear axle of your 2017 Toyota 4Runner is the Timbren Rear Suspension Enhancement System #TTORSEQ. These jounce-style springs will do a nice job of reducing rear sag on…

view full answer...

Will Timbren Rear Suspension Enhancement System Fit 2006 Toyota 4Runner

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching