Should Weight Distribution Bars Flex When Installed
Question:
I recently purchased the Curt 800 lb weight distribution system. My spring bars bow a little when hooked up. Does that mean that they are not stuff enough or strong enough for my trailer? Will this cause a problem when pulling?
asked by: Tony G
Expert Reply:
A slight bend in the spring bars of a weight distribution system is normal and just shows that they are doing their job. The bars are made of spring steel which is designed to flex. If they didn't flex the ride quality would be very rough.
Since you have an 800 lb tongue weight system you will need to be sure not to exceed this figure with the loaded tongue weight of your setup.
I attached a help article on determining tongue weight for you to check out as well.
Product Page this Question was Asked From
Curt MV Weight Distribution System - Round Bar - 8,000 lbs GTW, 800 lbs TW
- Weight Distribution Hitch
- WD Only
- No Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- 700 lbs
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Determining Trailer Tongue Weight
- Shop: Suspension Enhancement
- Search Results: tdr1500ds
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Timbren Rear Suspension Enhancement System
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Q&A: Which Timbren Kit for 2017 Ram 1500 Towing Trailer with 660 lbs Tongue Weight
- Q&A: Which Timbren Rear Enhancement Fits A New Body Style 2019 Ram 1500 Crew Cab 4WD?
- Q&A: Recommended SumoSprings for a 2021 Ram 1500 Pulling a Travel Trailer
- Q&A: Best SumoSprings For 2022 Ram 1500 Towing Camper Trailer
- Article: Using a Portable Generator on RV
- Search Results: 12 20 lug nuts
- Search Results: grease cap
- Search Results: ez lube cap
- Search Results: equal~i~zer
- Search Results: spindle nut
- Shop: etrailer Trailer Hitch Receiver Lock for 1-1/4" Hitches - Flush - 2-1/8" Span - Chrome
- Shop: Trailer Hitch
- Shop: Trailer Spindle Nut 1"
- Shop: Replacement Spacer Rivet and Washers for Equal-i-zer Weight Distribution Head
- Q&A: Can The 1-1/4 etrailer Trailer Hitch Receiver Lock # e98879 Be Keyed Alike?
- Search Results: 3 inch hitch extension
- Shop: Towing Mirrors
- Video: Curt Weight Distribution - WD With Sway Control - C17499 Review
- Article: 5 Things to Know About Weight Distribution Hitches
- Shop: Brake Controller
- Shop: Roof Rack
- Q&A: Can You Back Up with a Curt Weight Distribution System Installed
- Q&A: Which Curt Hitch Fits 2019 Subaru Impreza and is There Heat Shield Trimming
on Weight Distribution Hitch
