Timbren Suspension Enhancement Recommendation for a 2016 GMC Yukon XL

Question

Question:

I need a timbren for my 2016 GMC Yukon XL

asked by: Gil H

0

Expert Reply:

The Timbren system part # TGMRYS4 that you referenced has been confirmed as a fit for the 4 wheel drive and the 2 wheel drive models of the 2016 GMC Yukon XL so it would work well for you and would be a great choice to eliminate rear suspension sag.

I attached an install video for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Adding any after market bump stop/jounce bumper could potentially raise the vehicle 1" because they are longer than the factory bump stop however, they are compatible with the Magneride system. Adding them can potentially effect how the vehicle…

view full answer...

Answer 2

I spoke with my contact at Super Springs and the SumoSprings Custom Helper Springs, #SSR-204-40, will fit on your 2003 GMC Yukon XL with coil springs as long as it is a 1500 model. These springs are designed to replace your factory bump stops. Once…

view full answer...

Answer 3

I spoke with my contact over at Timbren about helper springs #TGMRYS4. The overall height of the whole assembly is 4-3/4 inches. The spring by itself is 3-3/4 inches. You'll want an inch to an inch and a half of space between the frame/axle and…

view full answer...

Answer 4

For your 2018 Cadillac Escalade the Timbren Rear Suspension Enhancement System #TGMRYS4 will work great. These jounce-style springs are confirmed to fit your vehicle and will simply replace the factory bump stop on the frame to provide additional…

view full answer...

Answer 5

In terms of capacity, the Timbren Rear Suspension Enhancement System, #TGMRG25C, for a 2003 Chevy Avalanche 1500 has quite a bit more; a total capacity of 6,000 pounds. Compare that to the maximum 1,000 pound capacity of the Firestone Vehicle…

view full answer...

Answer 6

Yes, the Timbren Rear Suspension Enhancement System #TGMRCK35S can still be used on your 2007 Chevy Silverado even though its been lifted. You'll just need to install a spacer to get the gap between the Timbren and the axle around 1" to…

view full answer...

Answer 7

It is not recommended to use any type of suspension enhancement when using a weight distribution system. The two systems will work against each other and would provide an unsafe, unpredictable ride quality. Your best option would be to make sure the…

view full answer...

Answer 8

What I recommend is going with the Timbren vehicle suspension #TGMRYS4 (2WD or 4WD)because the hollow rubber springs sit above the axle and they are easy to install. It will also be compatible with your auto-leveling system. Also, the Timbren…

view full answer...

Timbren Suspension Enhancement Recommendation for a 2016 GMC Yukon XL

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching