Is Mounting Hardware Included With The Dutton-Lainson Trailer Jack, # DL22580

Question

Question:

Is mounting hardware included with this jack? My retangular trailer tongue measures 2 1/4 height by 2 width. Will this DL22580 fit securely?

asked by: Peter B

0

Expert Reply:

The Dutton-Lainson Trailer Jack, # DL22580, does come with all the mounting hardware. The mounting hardware that comes with the jack is the Dutton-Lainson Mounting Hardware, # DL22443.

It will fit trailer tongues up to 3 inches X 5 inches, so it will fit your trailer securely. The jack has a 12 inch lift and a capacity of 1,500 lbs.

I am sending a video link of a similar jack being installed on a trailer.

expert reply by: Jeff D

0

Answer 1

I spoke to my contact at Dutton Lainson to get the dimensions you requested. The overall height of the jack when fully retracted is 26-1/2 inches. It measures 14-1/2 inches from the center of the bracket to the bottom of the jack wheel. It measures…

view full answer...

Answer 2

There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following options:…

view full answer...

Answer 3

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

view full answer...

Answer 4

For your application there really is only going to be a weld on solution that's reasonable like the part #UF48-979022 that you referenced. The frame dimensions are unknown so a weld solution would be better since that really doesn't matter.…

view full answer...

Answer 5

What you have there is a Dutton Lainson jack. There is no longer a direct replacement jack, but you can use the #DL22580 which will be an upgrade. This is a swivel jack with a 1,500 lb capacity and 12" of lift. This has dual wheels for easy…

view full answer...

Answer 6

The Dutton-Lainson Hand Winch - TUFFPLATE Finish - 2 Speed - Direct Drive - 2,500 lbs #DL14830 will only ratchet when being pulled in. The output will free-wheel and allow you to control that free-wheel speed with the integrated hand brake. The hand…

view full answer...

Answer 7

I reached out to my contact at Dutton-Lainson and the Dutton-Lainson Covered Hand Winch - 2 Speed - Freewheel - 25' Strap - 2,600 lbs #DL17085 will mount the same as your current DL1802A #DL14627. With that said the #DL17085 will be about…

view full answer...

Answer 8

Yes, since your current Fulton jack is a bolt-thru style, you can use the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR with your current welded on bracket. You just need to remove the jack from the included bolt-on bracket and mount it to your…

view full answer...

Is Mounting Hardware Included With The Dutton-Lainson Trailer Jack, # DL22580

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching