Length of Lippert Electric Stabilizer RV Jack Support Arm # 142433

Question

Question:

How long does this measure? I just want to make sure it is the same part. Just wondering the dimensions. Thanks

asked by: Veronica L

1

Helpful Expert Reply:

In total, the Lippert Electric Stabilizer RV Jack Support Arm, part # LC1134122 is 19.3 inches in length. Center hole to center hole distance is 17.8 inches. I've shown these dimensions on a photo I've edited for you.

expert reply by: Mike L

1

click to enlarge

Answer 1

You sure can! For your Lippert High-Speed Power Stabilizer Jack #LC298707 you'll want the: -Replacement Electric Stabilizer Jack Support Arm for Lippert RV Jack #LC1134122. This part is sold individually, so if you need all 4, you'd need to…

view full answer...

Answer 2

There are two replacement arms for the Lippert Components High-Speed Power Stabilizer Jacks, the Replacement Electric Stabilizer Jack Support Arm part #LC1134122 for yellow and part #LC1134121 for black. If you currently have yellow arms then you…

view full answer...

Answer 3

The Electric Stabilizer Jack Support Arm #LC1134122 and Foot Assembly #LC157584 are the only replaceable parts for the legs on your Lippert PSX1 Stabilizer Assembly #LC298707. If you bent the leg itself you will need to replace the entire assembly.

view full answer...

Answer 4

Since the leg of your Lippert Stabilizer jack setup part #LC298707 aren't replaceable you would need to replace the entire unit unfortunately.

view full answer...

Answer 5

The legs of the Lippert electric stabilizer jack you have are not replaceable. The only solution would be an all new stabilizer setup like the #LC369774 which is essentially the newer version of what you have now.

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 12

Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.

view full answer...

Length of Lippert Electric Stabilizer RV Jack Support Arm # 142433

Product Page this Question was Asked From

Continue Researching