Bearings, Races, and Grease Seal Recommendation for a 1995 Coleman Stoney Pop Up

Question

Question:

I have a1995 coleman stoney creek pop up camper. I have finally been able to find part numbers and was wondering if you have a kit to fit. Part numbers from Coleman: Grease seal: 4714A2201 Inner/outer bearing + race:4716-1101 Hub: 4738D0451 Slotted spindal nut: 4714-3068 Clotter pin: 1204-1268 Dust cap: 4714A0621 Universal part numbers it references: Inner/outter bearings: L44649 Grease seal: 13194TB Race: L44610 Any information that you have will be great. Thanks in advance The picture is a list of the part numbers.

asked by: Zack E

0

Expert Reply:

We have the bearings and seal that you would need, but they are not available in a kit.

For bearings you would want the # L44649, for races part # L44610, and then for a seal you would need part # 13194.

I attached a help article on replacing bearings, races, and seals on a trailer hub for you to check out as well.

expert reply by: Jameson C

0

Answer 1

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…

view full answer...

Answer 2

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm…

view full answer...

Answer 3

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 6

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

view full answer...

Answer 7

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Bearings, Races, and Grease Seal Recommendation for a 1995 Coleman Stoney Pop Up

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching