Will Air Lift Air Helper Springs, # AL60821, Fit a 2010 Ford Flex with Ecoboost

Question

Question:

I see that you have a rear suspension air bag kit for the 2010 Ford Flex. Will this kit also fit my 2010 Flex with the OEM ecoboost option which includes a slightly lowered suspension?

asked by: Claude

0

Expert Reply:

I spoke with my contact at Air Lift about Helper Springs, # AL60821, and your 2010 Ford Flex. He stated that he had no notes that stated that kit could not be used on models with the Ecoboost option and that it should fit your Flex. I have included a link to the installation details below.

expert reply by: Michael H

0

Answer 1

An option is to attach the bracket to the bottom of the bumper on your vehicle. For that you would want the part #18144.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

For standard 3,500 lb axles the correct bearing kit is the part #BK2-100 which comes with L44649 and L68149 bearings. Bearing Buddy Protectors #BB1980A-SS are the ones most commonly seen on 3,500 lb hubs. This is designed to fit a hub bore of 1.980…

view full answer...

Answer 7

Both of the trailer hitches available for your 2012 Ford Flex with dual exhaust have the same design and install in the same places on the vehicle so they will all look pretty much the same. The cross tube will be visible beneath the rear bumper but…

view full answer...

Answer 8

Brake controller wiring adapter #3035-P is the correct one for use with a Prodigy P3 controller #90195 in a 2016 Ford Explorer equipped with the factory 7-way trailer socket. This wiring adapter plugs in at the back of the controller and at the brake…

view full answer...

Answer 9

The Firestone Ride-Rite Air Helper Springs #F2550 for your 2011 Ford F-350 maintain an even load distribution using air pressure. The Firestone air bags' air pressure is adjusted for the weight of each individual load. This system includes air…

view full answer...

Answer 10

Thank you for your purchase of the Draw-Tite 2-inch hitch #76034 and the MaxxTow Aluminum Motorcycle Carrier MT70101. When a hitch carrier like this is installed and loaded up with a motorcycle (even a relatively light one like a smaller dirt bike)…

view full answer...

Answer 11

You sure can! To determine which components are going to fit your trailer you will need to determine the bearing combination your spindle uses. The easiest way to do this is by removing one of your current hubs and looking for the bearing numbers…

view full answer...

Will Air Lift Air Helper Springs, # AL60821, Fit a 2010 Ford Flex with Ecoboost

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching