bing tracking image
Q & A Icon

Brake Controller Recommendation for a 1991 Chevy G-30 Van  

Question:

hello, I have a 1991 chevrolet G-30 van. I am installing a 7 blade connector on it to tow a large dump trailer. I want to install a brake controller on it but I am unable to find a harness for what is NOT a plug and play set-up. I am leaning toward a P2 controller if I can get enough harness to custom wire the rest to the rear. Please advise if and how you can help me. I know its an old tow vehicle, but the miles are very low. Thank for any help

0

Expert Reply:

Since you have a 7-Way you will only need a few more components to complete a brake controller install on your vehicle.

First let's start with a brake controller. I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.

Next, for a wiring kit to install the brake controller and the 7-way adapter you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

I attached an FAQ on installing brake controllers for you to check out.

expert reply by:
0
Jameson C

Products Referenced in This Question



Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>