Where is C-800 Replacement Klauber Motor Made

Question

Question:

The Lippert motor was made in Idia. Mine didnt last long. It filled with water.

asked by: Pete

0

Expert Reply:

I did a little digging and found that Klauber motors are made right here in Missouri! So motor # LC138445 is made in the USA.

expert reply by: Michael H

0

Answer 1

I went to our warehouse and took some measurements of the C-800 Replacement Klauber Motor, part #LC138445. The center to center mounting hole distance is 2-5/8 inches. The shaft that attaches to the stabilizer is 1/2-inch diameter. The slot in the…

view full answer...

Answer 2

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

For your Geo Pro Camper with a 59" frame rails width the DrawTite Multi-Fit Motor Home Trailer Hitch part #82201 is an excellent choice. I like the really low profile it offers allowing it to fit snugly up under the camper. It mounts with the…

view full answer...

Answer 6

For your 2020 Forest River Geo Pro I recommend using the Adjustable Width Trailer Hitch Receiver #13703, this will fit most trailer frames; spanning from 22" to 72". This hitch will use the bolt holes on the frame of your trailer to mount,…

view full answer...

Answer 7

It sounds like when the Redarc Tow-Pro Elite Brake Controller #RED44FR was installed on your 2022 Toyota Highlander that they may have damaged the brake signal wire or tied into the wrong wire. I recommend taking it either back to the shop who…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 10

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

view full answer...

Where is C-800 Replacement Klauber Motor Made

Product Page this Question was Asked From

Continue Researching