Availability of Etrack Strap That Has One End that Attaches to Etrack and Hook on Other End

Question

Question:

Do yall make an etrack strap with one hook and ratchet?

asked by: Lee

0

Expert Reply:

We carry the part # IMF18800-87 which comes with two ratchet straps that have one end that will connect to the etrack and the other end has a hook on it. I attached a review video for you to check out as well.

I attached a review video for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Yes, if you needed to place items on top of E-Track such as #E19148 you can. I would stay within its rated capacity though which is 2,000 pounds working load limit. This would be assuming the weight is evenly distributed.

view full answer...

Answer 2

I may have a solution for you, but we don't have any angled trim that is 1-1/2" x 1". The closest available angled trim we currently have available is the Angle Trim for Enclosed Trailer - 93-1/2" Long x 3/4" Tall x…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Waylon, it does look like the Dexstar Steel Mini Mod Trailer Wheel #AM20539 is the same thing as the Dexstar 17-233 wheels you're referring too. These are silver wheels with a 6 on 5 1/2 bolt pattern, a 0 offset, and are made in the USA.

view full answer...

Answer 8

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

view full answer...

Answer 11

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Availability of Etrack Strap That Has One End that Attaches to Etrack and Hook on Other End

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching