Roof Rack Recommendations for 2014 Subaru Legacy

Question

Question:

Does the BOLT ON 46inch roof rack rhino I think, require removing the head liner for install??????

asked by: Doug L

0

Expert Reply:

The # RTS508 you referenced is meant for use on the Range Rover Sport, which have holes installed in the roof for the tracks to connect to. This track system wouldn't work on your Legacy.

Assuming that your 2014 Subaru Legacy has a bare roof, I'd recommend the Rhino Rack Euro Style Aero Bar Roof Rack, which is made up of # RRVA137B-2, # RRRLKVA, and # DK078.

These racks clamp to the roof using clips that grab onto the inside top door jambs of the vehicle. The clips are plastic coated, to prevent scratching the vehicle.

expert reply by: Mike L

0

Answer 1

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 2

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

Hey Luke, Sorry about the confusion, and we can 100% get your 2007 Honda Civic 4-door sedan set up with all the parts needed for a Rhino-Rack roof rack, including both crossbars. You would just need these parts: - Rhino-Rack Vortex Aero Crossbars…

view full answer...

Answer 6

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 7

Hey John, I used to have a 2013 Sienna, it was a great van. I can definitely help set you up with Rhino Rack Vortex Aero Crossbars for your 2014 Sienna. The Rhino-Rack #RRVA126B-2 that you mentioned is a set of crossbars only though, so additional…

view full answer...

Roof Rack Recommendations for 2014 Subaru Legacy

Products Referenced in This Question

Featured Help Information

Instructions

Continue Researching