Transmission Cooler and Fitting Adapter Recommendation for a 2015 Chevy Silverado 4.3 Liter

Question

Question:

Will this work with my 2015 Silverado?

asked by: Chris

0

Expert Reply:

Actually the hose fitting for installing a transmission cooler in your 2015 Chevy Silverado is the part # D13035 and not the # D13018 that you referenced.

A popular cooler for your vehicle is the part # D13503.

expert reply by: Jameson C

0

Answer 1

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 3

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 4

To install a brake controller on your 2017 Chevrolet Silverado 1500 LT 4x4, you will just need the vehicle specific plug-in adapter. These adapters are usually brand specific. For example, if you go with the Tekonsha Prodigy P3 brake controller,…

view full answer...

Answer 5

The Trimax King Pin Lock #TMX56RR can still be used with your 5th wheel having a capture plate from PullRite. The capture plate mounts to the top of the kingpin and only takes up a similar amount of space that a Lube Plate #RP83002 would. If you…

view full answer...

Answer 6

You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…

view full answer...

Answer 7

Given the weight of your trailer and the fact that you tow uphill I recommend going with the largest cooler or most efficient that will fit in the available space you have in the engine compartment of your 2004 Silverado. A stacked plate cooler is…

view full answer...

Answer 8

Since your 2017 Chevrolet Traverse does not have the factory connector but does have a rear air conditioning unit I recommend first checking to see if you have the factory tow package. You can locate the plug for the Tekonsha T-One #118270 at the…

view full answer...

Answer 9

For your 2003 GMC Sierra 2500HD with the 6.0L V8 engine, I highly recommend the Derale Series 8000 Plate-Fin Transmission Cooler Kit part #D13504. This 8000 series cooler measures 11" wide x 12" tall x 7/8" deep which will be a good…

view full answer...

Answer 10

The Chevy Vans are not actually pre-wired for a brake controller. A brake controller has to be partially hardwired in. If your 2007 Chevy Express came with a factory installed 7-Way trailer connector then the blue brake output wire should be ran from…

view full answer...

Answer 11

I would be happy to help! The Hopkins Endurance Multi-Tow Twist-Mount 7-Way RV and 4-Way Flat Trailer Connector - Vehicle End #HM40920 would only fit your 2010 Chevrolet Express Van 3500 if it has the factory towing package with a factory 7-way…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Transmission Cooler and Fitting Adapter Recommendation for a 2015 Chevy Silverado 4.3 Liter

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching