Can Yakima HoldUp Bike Platform Rack # Y02443-2 Be Used on Back of Class C Motorhome

Question

Question:

Can yakima four timer be used on the back of a class c Motorhome?

asked by: Bill F

0

Expert Reply:

The Yakima HoldUp Bike Platform Rack, # Y02443-2, is not approved for use on the back of a motorhome but I do have quite a few options for you.

I would suggest the Thule T2 Pro XTR # TH69TX. This is a great rack that is very versatile and will work on your motorhome. I have attached a video for you to check out.

For a more economical rack, I suggest the Swagman XTC4 # S64665. I also attached a video of this one so you can compare the two.

expert reply by: Leah S

0

Answer 1

Sounds like you are looking for a bike rack recommendation for the back of an RV. I really like the Yakima Long Haul part #Y02476. It's a high quality rack from one of the industry leaders in bike racks that has been reinforced for the…

view full answer...

Answer 2

I know it can be a bit confusing because a trailer hitch is a trailer hitch, but the reason the Yakima HoldUp 4 Bike Platform Rack #Y02443-2 isn't appropriate to install on your 5th wheel RV trailer hitch is simply due to the extra movement…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 5

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 6

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 7

I have a solution for you. Here at Etrailer, we strongly discourage using wheel-mounted bike racks like the Kuat NV 2.0 #NV22B for bikes with fenders. Mounting wheels with fenders can cause the fenders to crack or become damaged, especially with the…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 10

For an e-bike rack for your Letric XP step thru bikes at the rear of an RV the Swagman E-Spec part #S94FR would be a great choice as it's rated for the rougher ride quality at the rear of RVs, has the higher weight capacity needed at 60 lbs per…

view full answer...

Answer 11

The RockyMounts MonoRail bike rack you'd looked at, part #RKY10004 is a great bike rack, but it wouldn't work well with bikes that have fenders like your Aventon Aventure Fat tire ebikes. The front fender would prevent the bike retaining hook…

view full answer...

Answer 12

At the rear of a trailer or RV the ride quality is very rough when compared to the ride quality at the rear of a passenger vehicle. Reason being the suspension isn't as sophisticated and there is a longer distance between the rear axle and the…

view full answer...