Steering Stabilizer Recommendation for a 2000 Chevy Roadtrek Express Class B 3500

Question

Question:

Hi, I have a class B motorhome it is a 2000 Roadtrek 200 Popular RV on a 2000 chev express 3500 chassis and I was wondering if this steering stabilizer would work on my van. It looks like it would fit any 2000 express 3500 vans .Thanks Rick

asked by: Rick M

0

Expert Reply:

Yes, for the 2000 Chevy Roadtrek Express Class B chassis 3500 you would need steering stabilizer # RM-RBK15-RSSC that you have referenced.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Yes, for the 2002 Chevy Express Van chassis 3500 you would need steering stabilizer #RM-RBK15-RSSC that you have referenced. I have also included a link to our help article on heavy duty stability control for you to view.

view full answer...

Answer 2

Since it's a Class B RV your chassis is a cutaway so the correct rear sway bar is the part #RM-1109-175-00 but we do not have a front bar for your RV chassis. The good news is that the rear bar is the one that makes the biggest difference…

view full answer...

Answer 3

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 4

The air suspension system on your 2022 Ram 2500 limits your options for suspension enhancement. None of the air bags made for your truck will be compatible. Instead, I recommend adding the SumoSprings Rebel Custom Helper Springs #SS64VR. The…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 9

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 10

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...