Axle Diameter for the Rack'Em Trailer Dolly

Question

Question:

hole for axle size

asked by: Owen N

0

Expert Reply:

I went and pulled a part # RA20TIRE from our warehouse to measure the axle hole diameter and found that it measures 11/16 inches.

expert reply by: Jameson C

0

Answer 1

We do not offer a larger tire for the Rack 'Em #RA20TIRE trailer dolly. The axle diameter is 11/16 of an inch, and the rim is 6 inches in diameter. The tire size is 4.00 x 6.

view full answer...

Answer 2

So long as a hub uses the correct bearings that match the dimensions of the spindle that is on the axle there is no worry about using two different brands of products, such as a Dexter hub on a Lippert axle. That in itself is not a concern. When a…

view full answer...

Answer 3

You are correct, the Fulton Snap Ring, #FP908600, and Bulldog Snap Ring, #BD500241, are very similar. I went out to the warehouse and pulled both parts to measure them using digital calipers. Both had the following measurements: Inner diameter = 2.28…

view full answer...

Answer 4

Yes, the temperatures you mentioned are normal. If you were getting over 200 degrees that would be a bad sign. But typically if all of the hubs are the same temperature you're good and it's only really an issue if one of the hubs is hotter…

view full answer...

Answer 5

The Rack'Em Trailer Dolly #RA20 that you referenced can move along surfaces other than flat asphalt. The question of how hard would it be to move your trailer really has a lot to depend on the size of your trailer and the size of the person…

view full answer...

Answer 6

When fully retracted, or collapsed the jack is 28.58 inches tall, and 38.42 inches tall when extended as shown in the provided diagram. I've linked you to a product description video featuring the #ORJW1SU ARK Extreme Off-Road Ratcheting Trailer…

view full answer...

Answer 7

I would be happy to! The bottom of the foot to the center of the pipe mount is 10-1/2" when retracted and 24-1/2" when fully extended on the Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered Option item #TV64FR. Sorry I do not…

view full answer...

Answer 8

I will start by saying the ARK Extreme Off-Road Ratcheting Trailer Jack w/ Wheel #ORJW1SU will fit frames that are 2" to 6" tall. The bolt hole measurements vary and I included a diagram with everything listed, but the overall dimensions of…

view full answer...

Axle Diameter for the Rack'Em Trailer Dolly

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching