Would the BOLT Trailer Hitch Receiver Lock # BL7018446 fit a 2013 GMC Sierra 2-1/2 inch Hitch

Question

Question:

I have a 2013 gmc sierra 2500hd with the 2 1/2 inch hitch. Can you tell me if this lock will 100 fit the hitch. Have not been able to find 1 that works because they are all to short.

asked by: Tim

0

Expert Reply:

The BOLT Trailer Hitch Receiver Lock # BL7018446 has been confirmed as a fit for trailer hitches that are 2-1/2 inch by 2-1/2 inch like what you have on your 2013 GMC Sierra so it would work well for you.

What's really nice about this hitch lock is that it can be keyed to the key of your truck so you wouldn't have to add an additional key to your keyring.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a 2" receiver we do have the B&W #BWRHXA2182 if you need to use your 2" ball mount or hitch mounted…

view full answer...

Answer 10

Since the Truxedo Lo Pro you'd have installed on your 2013 Chevy Silverado 3500HD long bed would be the part #TX571601 the correct replacement tarp would be the part #TX5716-CVR.

view full answer...

Answer 11

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

view full answer...

Answer 12

The Air Lift Wireless AIR Compressor System #AL74000 will show an error whenever there is any type of issue with the system. Generally this is an issue with the remote communicating with the system, a blockage, or a leak. I would inspect the…

view full answer...

Would the BOLT Trailer Hitch Receiver Lock # BL7018446 fit a 2013 GMC Sierra 2-1/2 inch Hitch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching