What Wire Gauge to Use to Install Optronics Thin-Line LED Racing Light Kit # LS-108
Question:
What gauge wire do I need to use with the inline fuse that hooks to battery
asked by: Nate J
0
Expert Reply:
10-gauge wire like # 10-1-1 is typically used for 12V power feeds for a trailer connector but in the case of super-efficient LED lights like the Optronics Thin-Line LED Racing Light Kit # LS-108 you are fine using lighter 12-gauge wire # 12-1-1. LEDs draw about 1/10th of the power required by standard incandescent lights so you'll be just fine with this 12-gauge wire for your installation.
expert reply by:
Adam R
0
Products Referenced in This Question
Product Page this Question was Asked From
Optronics ThinLine LED Racing Light Kit w/ Harness and Power Switch - 12 Diodes - Oblong - Qty 2
- LED Strip Lights
- Rigid Light
- Exterior Light
- Hardwired
- 0 - 10 Inch Long
- White
- Optronics
more information >
Continue Researching
- Q&A: Recommended Roof Vent Upgrade for a Dometic EZ-Breeze
- Q&A: Can I Install the Thinline LED Trailer Tail Light Vertically Where It Will Be Submerged?
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Q&A: Can FloTool RhinoRamps Max Vehicle Ramp Set Hold the Weight of a 2021 Ram 3500
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: How Much Does the B&W Companion OEM 5th Wheel Hitch for Ram Towing Prep Package Weigh
- Article: Trailer Maintenance Schedule
- Q&A: Can OEM Hitch on 2021 Jeep Gladiator Be Replaced with Draw-Tite 76310
- Article: Trailer Wiring Diagrams
- Article: What Exactly is Tongue Weight?
- Article: What is Boondocking
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Charge a Dump Trailer Battery