Availability of Trailer Chrome Hubcovers

Question

Question:

2005 HALLMARK trailer chrome hubcovers? Still make them?

asked by: Jim

0

Expert Reply:

We sell several different hub covers that could work on your 2005 Haulmark trailer. To see them you would need to check out the link I attached. You will need to know how many lugs your trailer wheels have to see what would fit.

For a chrome version of the part you referenced you would want the part # QT655C.

expert reply by: Jameson C

0

Answer 1

The 1-3/4 inch length of the Replacement Cam Lock Cylinder #295-000077 refers to the overall length of the cylinder. We also have 7/8 inch part #295-000003. 1-1/8 inch #295-000004 1-3/8 inch #295-000005

view full answer...

Answer 2

Since you have a 6 lug wheel the correct cover you would need is the part #QT655B which is black and will fit and work well.

view full answer...

Answer 3

It looks like the wheels on your 2008 Forest River Sierra have the 6 on 5-1/2 bolt pattern so #QT545C would not fit because it is for the 5 on 4-1/2 bolt pattern. The 6-lug version of the cover is #QT655C. There is also a black one you can use,…

view full answer...

Answer 4

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

view full answer...

Answer 5

The Solera RV Slide-Out Awning #LCV000168112 will fit your RV's slide out that measures 167" including the flange, and 37" long. This awning will fit slide outs that are 164-169" wide and up to 48" long. However, you will need…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 12

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Availability of Trailer Chrome Hubcovers

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching