Fender Recommendation for a US Cargo Utility Trailer

Question

Question:

Could I bolt these fenders on a US Cargo trailer using the backing plate? My original Jeep style fenders are bolted on through the backing plate. Trailer model is uscl510sa. Thank you...

asked by: Martin L

0

Expert Reply:

There's no reason you couldn't bolt the Single Axle Trailer Fender w/ Backing Plate # HP36VR to your trailer.

I attached a couple pictures for you to check out that have the fender dimensions for you to compare to your trailer.

expert reply by: Jameson C

0

click to enlarge

Answer 1

All of the 2015 Honda Pilots would have a hitch installed on them from Honda. So that is one less piece of the puzzle that you would need. Since you wanted to do some towing you might be interested in etrailer ball mount kit #989900. It comes with 2…

view full answer...

Answer 2

It looks like all 2015 Honda Pilots come equipped with a hitch already (save for a select few). It's for that reason that none of our manufacturers made hitches for it, and why the 2016 hitches will not fit. In the middle of your back bumper, you…

view full answer...

Answer 3

There are 2 different capacities independent of each other though related. Tongue weight is the downward force or weight on the trailer hitch. So it is pushing down at the back of the vehicle. The gross trailer weight is the weight of whatever it is…

view full answer...

Answer 4

The Curt Adjustable Width Trailer Hitch Receiver for RVs #13703 uses frame brackets for installation, and those need to be positioned on the inside of an I-beam frame, as per the instructions (a copy of which I have linked for you). That is what will…

view full answer...

Answer 5

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 6

view full answer...

Answer 7

The B&W Companion OEM 5th Wheel Trailer Hitch #BWRVK3700 is perfectly compatible with cushioned pin boxes like your MORryde RP072-1621HD, so the clunking you're experiencing isn't related to the two components being incompatible. With…

view full answer...

Answer 8

It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a bit smaller than the slots they slide into for mounting otherwise you'd have a hard time getting your hitch in…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The Thule WingBar Evo Crossbar System part #TH711520, part #TH480R, and part #THKIT1803 while installed on your 2019 Toyota Highlander will indeed need to be positioned so that the door clip is located 13-1/4" back from the rubber molding…

view full answer...

Answer 11

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

view full answer...

Answer 12

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Fender Recommendation for a US Cargo Utility Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching