Ground Clearance After Installing a Hitch on a 2014 Ford Fusion

Question

Question:

what is my ground clearence on a 20014 fusion

asked by: Jim L

1

Helpful Expert Reply:

When we installed the Curt Hitch # C12091 on a 2015 Ford Fusion we found that from the top of the hitch opening down to the ground it measured 11-1/2 inches.

From the bottom of the hitch to the ground would be about 10 inches.

I attached an install video for you to check out as well.

expert reply by: Jameson C

1

click to enlarge

Answer 1

It is not recommended to reinstall the lower body fascia with the Curt Class II Trailer Hitch, #C12091, on your 2013 Ford Fusion Titanium because of the final position of the hitch once it is installed. It may be possible to mount the fascia with the…

view full answer...

Answer 2

Before deciding on a trailer to tow with your 2014 Ford Fusion, knowing the towing limitations of your vehicle will be an important factor. In the owner's manual for the 2014 Fusion, it lists the maximum trailer weight of all the powertrain…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Alec, For your 2016 Ford Fusion I recommend the recommend a roof rack from Inno: Inno Aero Crossbars #INXB138-145 Inno Through Feet for Aero Crossbars #INXS250 Custom Fit Kit for Inno XS200, XS250, and INSU-K5 Roof Rack Feet #INK860 As with any…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Assuming you are in that 9-10" range you can use the Draw-Tite Ball Mount #80248. This has a 9-3/4" rise and a gross towing weight of 3,500 lbs which would be perfect for your trailer. You will also need #C40002 for a 1-7/8" ball or…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 9

We offer adapters so you can use the 2 inch bike rack with the 1 1/4 inch receiver hitch. The appropriate adapter for your hitch depends on what class it is. You can use part #HTAD if your hitch is a Class I or Class II and part #80303 will only fit…

view full answer...

Ground Clearance After Installing a Hitch on a 2014 Ford Fusion

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching