Inside Diameter of Male and Female Ends on Camco Water Hose Brass Elbow # CAM22605

Question

Question:

What is the inner most diameter of the male and female end of the Camco Water Hose Brass Elbow - 45 Degree? From you photos it looks the opening narrows quite a bit beyond the washer. CAM22605

asked by: Brian

0

Expert Reply:

I pulled a sample of Camco Water Hose Brass Elbow # CAM22605 from our warehouse so that I could take its measurements for you. The inner diameters of the male and female ends are shown in the linked photo.

On the male end the larger outer diameter is 0.8-inches and this tapers down to 0.55-inches. On the female end the larger diameter (between the threads) is 0.97-inches and this too tapers down to 0.55-inches.

expert reply by: Adam R

0

click to enlarge

Answer 1

The Camco 90-Degree Water Hose Brass Elbow #CAM22505 has the same 1-inch fittings and thread pitch as a standard garden hose. I went to our warehouse and measured the male and female ends and confirmed both have this nominal 1-inch size. Please refer…

view full answer...

Answer 2

If you are okay with drinking from a garden hose then the Camco Water Hose Brass Elbow #CAM22605 that you referenced would work well for you. It's made of the same material (brass), as the fittings of a garden hose so you would be just fine…

view full answer...

Answer 3

The flexible Tank Wand part #A01-0187VP is going to be able clean better than the fixed since you can more easily push it down into plumbing and manipulate it to get it to clean where you want it than the rigid #A01-0184VP.

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Inside Diameter of Male and Female Ends on Camco Water Hose Brass Elbow # CAM22605

Product Page this Question was Asked From

Continue Researching