Installing a Transmission Cooler on a 2010 Chevy Avalanche

Question

Question:

Does the Chevy avalanche already have a transmission cooler and it?and whats an average cost on how much it would be to install one

asked by: Rich

0

Expert Reply:

There are a few transmission coolers that fit your 2010 Chevy Avalanche and the price will vary. I included a link showing you all the transmission coolers we currently offer for you to look at.

Your Avalanche will have a factory cooling system but not a transmission cooler. Obtaining one will prolong the life of your transmission and improve it's overall performance.

The Derale transmission cooler I recommend is # D13504 because it's a plate and fin cooler. The plate and fin cooler forces fluid through smaller plates causing agitation of the fluid. See the diagram I included showing you the best location to install.

You will also need a hose fitting # D13035. It will easily install the transmission cooler without having to cut or flare any lines.

I would contact your local mechanic regarding installation cost since it could vary.

I included a couple informative articles for you too.

expert reply by: Chris B

0

click to enlarge

Answer 1

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 4

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

From my research on the Harbor Freight 4x8 folding trailer uses 4.80-12 tires on a 12 inch wheel for the 1195 lb capacity trailer and a 5.30-12 for the 1720 lbs capacity trailer. It is a good idea to check your existing tires to see which size they…

view full answer...

Answer 12

Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…

view full answer...