Replacement Roof Vent Cover for a 1992 Dutchman Travel Trailer

Question

Question:

What roof vent cover would I need for a 1992 24ft Dutchman travel trailer?

asked by: Blake

1

Helpful Expert Reply:

Ventline does not offer a trailer/RV fit list for the vent covers so you will have to go by the measurements and the hinge style. Most all covers measure 14 inches square but there are various hinge styles: 3-point, 4-point, and continuous. I have included a picture showing the differences and a link to all of the vent covers we carry.

expert reply by: Michael H

1

click to enlarge

Answer 1

Most likely we have what you are looking for but you will need to first determine what vent you have on your trailer. In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly…

view full answer...

Answer 2

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 3

The closest option we have to what you described in your question is the Ventline Dome Assembly in White #BVD0449-A01 or Smoke #BVD0449-A03. This cover measures 14 inches x 14 inches and features a continuous plastic hinge (see attached image). I…

view full answer...

Answer 4

You would want to measure the distance of the opening of the vent. The Vent Cover #BV0554-03 that you referenced fits 14-1/4 by 14-1/4 inch openings. Nearly all roof vents are 14-1/4 inch by 14-1/4 inch. You probably have one of the styles that we…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Replacement Roof Vent Cover for a 1992 Dutchman Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching