Coupler Repair Kit Availability for a Trailer

Question

Question:

I have a bent underjaw on a coupler on a lippert frame. Will this curt coupler repair kit or just the underjaw work with the coupler I have? This is on a forest river R Pod trailer.

asked by: Tim

0

Expert Reply:

We have several different coupler repair kits that could work for you, but without knowing the brand, size, or style of your coupler it is hard to say if the # C25194 would be the correct one for you.

What I would recommend you do is check out the link I attached (after determining what brand coupler you have), click the brand of coupler you have and you will see all of the compatible coupler repair kits.

expert reply by: Jameson C

0

Answer 1

The repair kit installs as follows: The latch assembly bolt is slid through the coupler. Slip the large spring over the bolt. The under jaw comes next, followed by the square plate, the small spring washer and the lock nut. Take a look at the…

view full answer...

Answer 2

For your 1779 outer and 2788 inner bearings you will want the following parts. Replacement Trailer Hub Bearing - 1779 item #1779 Replacement Trailer Hub Bearing - 2788 item #2788 The closest seal we have to a National 5970 is item #29031 which has…

view full answer...

Answer 3

The type of brake assembly shown in your photos were commonly used on mobile home axles and older travel trailers. We do not carry this style of brakes for this style of trailer. However, if you could provide a little more information I would be…

view full answer...

Answer 4

All hubs for 15-inch wheels in your 5-on-4-1/2-inch bolt pattern are shown on the linked page. These include both idler hubs for trailers without brakes and hub/drums for trailers with drum brakes. These various hub parts are compatible with axle…

view full answer...

Answer 5

The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 8

The 1-7/8 inch width is what is rounded up to 2 inches which is a standard width for winch straps. The 14 foot length is not something we carry. I recommend the Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs #DL24239 or…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 11

The #37213635 JR Products Replacement Landing Gear Switch you'd mentioned would be a proper replacement for your existing Atwood 70254 landing gear switch. If you wanted the switch, wiring harness and the bezel for the switch, use the Stromberg…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Coupler Repair Kit Availability for a Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching